, CATH-TECH Reflow Clam Shell

Reflow Clam Shell

The CT Reflow Clam machine differs from CT Reflow Chamber machine because of its ability to be programmed to skip over various parts of a catheter assembly, therefore removing heat from designated parts of the catheter.

Description

The CT Reflow Clam uses a split die design that opens and closes around the needed parts where heat is necessary. This is especially advantageous should a catheter assembly have sensitive sensors or other materials in it where heat should not be applied. Additional features can be added to the Clam Shell Chamber including: Operator safety precautions, Ease conversion to CT STRETCHER, Loading elevators can be added for operators to load assemblies at lower levels.

Specifications

  • Chamber Options:
    • 8 or 10 Chambers
  • Height Options:
    • 89″, 100″, 108″, 120″, 144″
  • 5″ inches Chamber length (STD size)
  • Chambers inter-swappable – hot or cold
  • 2 pin per screw
  • Per changeover (less than 10 mins)
  • Low maintenance required
  • Crated weight 900-1000 lbs (STD)
  • Clam shell 1200 lbs. 3 phase
  • 208-240 VAC 30 AMP
  • Air pressure – minimum 90 PSI
  • Easy setup

Options

  • High Temp Package
  • Loading Elevator
  • Light Curtain
  • Safety Pull Cord
  • Door Interlock
  • Replacement PTFE
  • Replacement Chambers:
    • .200 – .375 Dia
    • .187 Dia
    • .376 – .500 Dia
    • .125 Dia