Our versatile machines are workhorses which require a smaller footprint than similar machines yet excel in demanding high production environments where the name of the game is high volume at low cost. A 3.75” diameter fiberglass rod can be plunged down producing two 3.75” balls in 2 minutes, in comparison to alternative process where the material is turned in 10 minutes consuming a large number of turning tools in the process. Another example, 6 to 8 golf ball cores can be ground round to under 0.002” in 15 seconds. Countless consumer goods can be ground on a range of Glebar machines.
Manufacturers use lapping machines which are unable to hold consistent tolerances or capacity, creating inconsistent surface finishes and longer cycle times.
Provide a form grinding solution for 1" and 1.4" deodorant balls while meeting the customer's cycle time and surface finish requirements.
Legacy equipment did not meet current CE standards. The brittle shafts break in the grinder's feeder increasing scrap rates.
Deliver an automated, turnkey process that can integrate with the customer's existing isostatic press to accuractely handle and grind the parts. The process had to ensure the ceramic shafts would not chip or break due to the brittle consistency of pre-sintered ceramics.
A top tier technical glass OEM required a precision grinding solution for quartz glass rod components which will be transformed into fiber optic cable cores. They needed to improve their existing process to increase output while maintaining a small footprint in their factory. Precision is paramount as the glass will ultimately need to transmit light over long distances without any boosting and without losing any of the information that has been encoded onto that light.
Challenge: A food equipment manufacturer approached Glebar to improve productivity and reduce costs for their food filler machines. The metal spout requires grinding for several reasons. They come in contact with food, therefore requiring a smooth finish for sanitary purposes. The tubes are often exchanged on the machines to dispense various size pastries. Also, the mating housing for the spouts must be a close fit to prevent leaking and to keep appropriate content pressure to dispense the precise amounts. Eight different components needed to be ground, all approximately four-inches in length, however they varied in diameters and weight. The variation of part geometries posed the biggest feeding challenge. Rapid changeover of grinding wheels was important to reduce setup time between the components.
Challenge: To end grind printed circuit board carbide drill blanks used by a major tool manufacturer to qualify the blank before fluting. The existing method relied on a batch process where parts were placed, a stack at a time, into a fixture and surface ground. Control over the length was highly dependent upon the setup of each batch in the machine, and length adjustment and perpendicularity were cumbersome to adjust for small diameter parts. Existing machines on the market were extremely large in comparison to the small diameter of the part to be processed, and were very expensive.
Below is a sample of select components Glebar has ground over the years. Please contact us and send us your drawing for a personal consultation.